Aneroid Sphygmomanometer

Description of Aneroid Sphygmomanometer
Our aneroid sphygmomanometer has fine quality, which will allow you to monitor your blood pressure easily and effectively anywhere and at any time.

Applications of Aneroid Sphygmomanometer
For Hospital, home, office, school and travel use.

Operation and Precautions of Aneroid Sphygmomanometer
1. Relax yourself and adjust to a proper position
It is very important that the person whose blood pressure is being taken is relaxed and sitting comfortably.
Keep arm being measured at heart level. Arm extended but not too tense or stiff. Rest arm on a flat surface, such as a desk with the left palm facing upwards. Keep arm being measured still.
2. How to put on the Velcro cuffs and chestpiece.
Place the cuff 2-3cm above the bend of the elbow on the naked left upper arm. Close the cuff by means of the Velcro closure. Cuff should be sung. But not too tight, One or two fingers should fit between cuff and arm. Never place cuff over article of clothing.
For cuff with metal D-shaped ring, pull the free end of the cuff through the D-ring and closed the cuff by means of the Velcro closure.
In units intended for home use, the diaphragm of the chestpiece of the stethoscope integrated into the cuff must be placed above the brachial artery.
3. Inflating the cuff
Closed the air valve on the bulb by turning the screw clockwise, Do not over-tighten.
Squeeze the inflation bulb with the hand you used to at a steady rare unit the needle on the gauge points 30mmHG above your normal upper-systolic-pressure valve. If you don’t know it, inflate just to 200mmHg.
4. Systolic blood pressure reading-upper value
Slowly open air valve y turning screw counter-clockwise and hold stethoscope chestpiece over brachial artery. Proper deflation rate is vital for an accurate reading, so you should practice and master a recommended deflation rate of 2-3mmHg per second or a drop of one to two marks on the pressure gauge each heartbeat. You should not keep the cuff inflated any longer than necessary. As the cuff begins to deflate, you must listen carefully with the stethoscope. Note the reading on the gauge as soon as you hear a faint, rhythmic tapping or thumping sounds. This is the systolic-upper-blood pressure reading. Listen carefully and familiarize yourself with pulse sound. Once familiar you should check this procedure with your physician.
5. Diastolic blood pressure reading-lower value
Allow the pressure to continue dropping at the same deflation rate. When your diastolic rate. When your diastolic-lower-blood pressure value reached, the thumping sound stops.
Deflate the cuff valve completely. Remove the cuff from arm and stethoscope from ears.
6. Record your readings
Repeat the measurement two or more times. Do not forget to record your reading and the time of the day measurement is made immediately after you finish measuring. A convenient time is first thing in the morning. Or just before evening meals. Remember that your physician is the only person qualified to analyze your blood pressure.

Maintenance of Aneroid Sphygmomanometer
With proper care and maintenance, your blood pressure kit will provide years of satisfactory service. The basic rules:
1. Do not drop or jar.
2. Never inflate beyond 300mmHg.
3. Never expose the cuff fabric or parts with a sharp instrument, since this could cause damage.
4. Always deflate cuff completely before storage.
5. Do not dismantle manometer under any circumstance.
6. Store complete instrument in storage case provided, to keep the chestpiece and all the other parts clean.
7. Storage temperature condition: -20 to 70 at relative air humidity of 85% (non-condensing).
8. Wipe off the manometer and bulb with damp cloth sterilization is necessary. Since the parts do not come into direct contact with the patient’s body.
9. Remove the bladder first, and wipe the Velcro, bladder and tubes with damp cloth. The cuff can be washed with soap and cold water like all the other cuffs, but you must rinse the cuffs with clear water afterwards and let them air dry.

Landytop is a professional manufacturer and supplier of aneroid sphygmomanometer in China. We provide four models of aneroid sphygmomanometer for customers, such as BS-2000, BS-20A, BS-20C, and BS-20D. We possess 10 years’ experience of producing, selling and serving. Our products also passed CE certification. Our company’s products have been exported to Egypt, Syria, Afghan, Indonesia, Lebanon, Nigeria, Yemen, Peru, Iraq, Pakistan, USA, Canada, and Mexico. If you need aneroid sphygmomanometer, please contact us and we hope you can visit our factories by yourselves. You can by T/T, Western Union, Credit Card, and Paypal to complete the transaction.